Tyan Thunder K7
S2462 Tyan Thunder K7 Dual Processor Motherboard
$49 including shipping
Processor
• Dual PGA462 ZIF sockets
• Supports up to two AMD Athlon MP processors
• Two onboard VRMs
• Front-Side Bus support for 266/200MHz
Chipset
• AMD-760 MP chipset
• AMD-762 north bridge & AMD-766 south bridge
• Winbond™ W83627HF Super I/O ASIC
Memory
• Four 184-pin 2.5-Volt DDR DIMM sockets
• 25° angled sockets enable rackmount installation
• Supports up to 4GB * of Registered DDR 200/266
• Supports ECC (72-bit) memory modules
* Note: The AMD-760 MPX requires a portion of memory to be reserved for PCI devices. Allocation for these devices is dependent on the number of PCI devices installed, and option ROM for each device. Common configurations will see 3.5GB to 3.8GB of available memory.
Expansion Slots
• One AGP Pro 50 slot
• Five 64/32-bit 33MHz (5-volt) PCI slots
• Total of six usable slots
Integrated I/O
• One floppy connector supports up to two drives
• Two 9-pin 16550-based serial ports
(one header and one connector)
• One 25-pin SPP/ECP/EPP parallel header
• Four USB ports (two stacked rear connectors
and two front panel headers)
• PS/2 keyboard and mouse ports
Integrated SCSI (option)
• Adaptec AIC-7899W controller
• Dual-channel Ultra160 SCSI support
• 160MBps maximum data throughput
• Supports up to 15 LVD SCSI devices per channel
- Channel A: 68-pin connector
- Channel B: 68-pin connector
System MonitorSystem Management
• 3-pin fan monitoring headers
• Winbond W83782D hardware monitoring ASIC
• CPU temperature and voltage monitoring
• System Monitoring Software: here
Integrated PCI IDE
• Dual-channel master mode
• Supports up to four enhanced IDE devices
• Support for DMA100/66/33 IDE and
ATAPI compliant devices
Integrated LAN
• Two 3Com 3C920 LAN Controllers with
3C980 Server NIC Firmware
• 10/100Mbps data transfer rate per controller
Integrated Video
• ATI® RAGE™ XL graphics accelerator
• 4MB frame buffer (SDRAM)
• Standard 15-pin analog VGA port
BIOS
• Phoenix BIOS 4Mbit Flash ROM
• User settings for hardware monitoring
• Auto-configuration of IDE hard drive types
• Multiple boot options; DMI 2.0 compliant
Form Factor
• Extended ATX footprint (13" x 12")
• One 24-pin and one 8-pin power connectors for
ATXGES Power Supplies only
• Stacked parallel (one), serial (two) and
VGA (one) ports; side-by-side LAN (two) ports
• Stacked USB (two) ports
• Stacked keyboard and mouse ports
• Recommended Power Supply & Chassis
Regulatory
• FCC DoC (Declaration of Conformity) certified
• European CE (Declaration of Conformity)